If your kibble is bigger or smaller, you will have to adjust accordingly. For us, we used a 1/2-inch drill bit for the final hole size. As the pipe is round, holding the bit where you want it to be is challenging, so having a point to guide you will make it a lot easier. For the holes, we recommend using a small pilot hole before creating the size of hole you want. Now that we have the body of the PVC dog feeder done, we’ll finish it by making the holes & preparing it for your pup. ![]() We recommend leaving the caps off at this point as the next step will be much easier if you’re able to see inside the pipe. The ends will be covered by a cap, so the most important thing is any loose PVC shavings. We like to feel the pipe gently by hand to make sure everything is smooth, so it doesn’t cut your pup by accident. We started with 1 ft, as we have 70+ lb dogs and it helps the feeder not go under our couches when it’s being used.Īfter we have the segment of pipe, make sure to sand down any edge of the PVC to prevent your pup from ingesting any PVC shavings or getting cut by sharp edges. We recommend oversizing it, as you can easily cut off more if you find it is too long later. If you weren’t fortunate enough to get a 1 ft segment of PVC, you’ll have to start with cutting the pipe to whatever size you wish for the PVC dog feeder to be.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |